|
Who's Online
There currently are 5902 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Great manual, great price. Has a few of the basic operating instructions that most service manuals leave out. Complete instructions for disassembling board by board, safety precautions, schematics, complete parts list.
;
I am very pleased with the service manual for my RT-909. This was an easy purchase and great procuct, and much cheaper than other venues i had looked at. This web site is now listed in my favorites list. KEEP UP THE GOOD WORK. THANKS. J. BROWN
;
A very well written and easy to understand manual.
;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
5
8. OPERATIONS
5
Gain Control Power Indicator
If the sound level is too low, even when The power indicator lights when the volume of the car stereo used along power is switched on. with this power amplifier is turned up, turn gain control on front of the power amplifier clockwise. If the sound distorts when the volume is turned up,
BFC (Beat Frequency Control) Switch turn the gain control counter-clockwise.
MW/LW broadcast with your car stereo, change the BFC switch using a small stanan RCA equipped Pioneer car stereo with dard tip screwdriver. max. output of 4 V or more, adjust level to
6
� When using with an RCA equipped car If you hear a beat while listening to an
stereo (standard output of 500 mV), set to the NORMAL position. When using with
6
match the car stereo output level.
PRS-A500/X1H/EW
Cut Off Frequency Control LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch
7
7 LPF (Left) * � 40 to 120 Hz Subwoofer Connect a subwoofer. OFF (Center) Full range HPF (Right) * 40 120 Hz � Full range Use if you want to cut the * See the �Cut Off Frequency Control� section. D E
If the LPF/HPF select switch is set to Set LPF/HPF select switch as follows according to the type of speaker that is connected LPF or HPF, you can select a cut off to speaker output connector and the car stereo system: frequency from 40 to 120 Hz. LPF/HPF Select Audio frequency range Speaker Remarks Switch to be output Type
very low frequency range* because it is not necessary for the speakers you are using. 8
8 B A C
27
F
|
|
|
> |
|