|
There are currently no product reviews.
 ;
Again very good service manual, this time very fast download. AAAAA+
;
Ckear manual, well reproduced with plenty of overlap on critical pages.
;
I buy the service manual cheaper here than in elsewhere.Am happy with this site. I recommended the Owner-Manuals.com
;
Great Manual. It was exactly what I was looking for
;
Great Manual. It was exactly what I was looking for
5
6
7
8
Note) This product has high voltage circuits inside, and the voltage will be kept for a while by big capacitors. So, before starting disassembly(especially removing the Buss Bars(CND3947)), make sure if the voltage of +VH and -VH become low enough after turning off the power supply(+B & ACC). If you want to discharge the capacitors faster, connect the resistors of same value in parallel with the original discharge resistors (R241 - R246).
A
- Removing the Amp Unit (Fig.3)
1
Remove the eight screws and then remove the four Buss Bars.
2 3 4 5
Remove the two screws. Remove the four screws.
B
Remove the seven screws.
Disconnect the Connector and then remove the Amp Unit.
C
Note) Removal of substrate while the Buss Bar being connected will deform the Buss Bar, failing to set up again. Buss Bar
1
1 5
1 1
1
3
1 4
1 4 4
1
3
3
4 4 4 4
D
3 2
2
Amp Unit
Fig.3 Note) Remove a screw for MODE SELECT only when switching over the mode selection.You do not have to remove this screw when removing the unit board. (Fig.4)
E
Screw for MODE SELECT Fig.4
F
PRS-D2000SPL/XU/UC
5 6 7 8
15
|
