|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent quality service manual. Quick processing, fair prices. Love to do business again. Thank you!!!
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
PT-FW100NTU / PT-FW100NTE / PT-FW100NTEA
7.11. Removal of S1-P.C.Board 7.8. Removal of L-P.C.Board
1. Remove the upper case according to the section 7.2. "Removal of Upper Case". 2. Open the front door. 3. Unscrew the 1 screw and remove the front cover (inside). 4. Unscrew the 1 screw and remove the grounding terminal. 5. Unscrew the 2 screws and remove the power separation wall. 6. Remove the front cover. Note: · S1-P.C.Board and S2-P.C.Board are attached. · Remove the front cover after shifting the projection lens upward. 1. Remove the block of Analysis Block, LCD Block and Projection Lens according to the steps 1 through 8 in the section 7.17. "Removal of Analysis Block and Projection Lens". 2. Unscrew the 1 screw and remove the L-P.C.Board.
7.9.
Removal of PI-P.C.Board
1. Remove the ARF drive unit according to the section 7.27. "Removal of ARF Drive Unit". 2. Unscrew the 1 screw and remove the PI-P.C.Board.
7. Disconnect the connector between S1-P.C.Board and S2P.C.Board. 8. Unscrew the 5 screws and remove the S1-P.C.Board.
7.10. Removal of R-P.C.Board
1. Remove the upper case according to the section 7.2. "Removal of Upper Case". 2. Disconnect the connector (S4 or A27) between RP.C.Board and A-P.C.Board. 3. Unscrew the 1 screw and remove the R-P.C.Board.
7.12. Removal of S2-P.C.Board
1. Remove the front cover according to the steps 1 through 6
16
|
|
|
> |
|
