|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
An excellent document to assist in the repair of my old personal tape player. It includes full circuit diagrams and physical layout drawings and full instructions on disassembly and fault finding.
Well worth the meagre price.
;
Very good conversation, Pretty fast Service, wood do it again,
Have paid by Paypal, so i got the Service Manual online after 15 Min.
Very helpfully.
Greeting from Germany,
Hans
;
Good-quality scans. Detailed description. I hope I can repair the machine.
;
High-quality scanning. Detailed description. Recommend for all technician. A+++
;
This is a good quality scan of the original Service Manual from Nordmende, Germany. Contains the circuit diagram, PCB layout, adjust/tune instructions as well. It is NOT in English but in GERMAN language! That was quite right for my german friend from the lower east side in Berlin.
PT-LB80NTU / PT-LB80NTE / PT-LB80NTEA / PT-LB80U / PT-LB80E / PT-LB80EA / PT-LB75NTU / PT-LB75NTE / PT-LB75NTEA / PT-LB75U / PT-LB75E / PT-LB75EA
7.2.
Removal of Upper Case
1. Turn the projector upside down. 2. Unscrew the 7 screws.
6. Unscrew the 12 screws and remove the connector metal fittings. Note: · For PT-LB80NT**/LB75NT**, WL-P.C.Board is attached on the connector metal fittings. Be careful with handling.
3. Return the projector to the normal position. 4. Remove the upper case.
7.3.
Removal of A-P.C.Board
1. Remove the upper case according to the section 7.2. "Removal of Upper Case". 2. Loosen the 2 screws until they idle, remove the lamp unit cover. Note: · For the interlock switch damage prevention when reassembling, must remove the lamp unit cover. 3. Unscrew the 2 screws and remove the connector cover.
7.4.
Removal of K1-P.C.Board and K2-P.C.Board Block
1. Remove the A-P.C.Board block according to the steps 1 through 5 in the section 7.3. "Removal of A-P.C.Board". 2. Loosen the 3 screws until they idle, remove the lamp unit with the handle. 3. Unscrew the 3 screws and remove the block of Analysis Block, LCD Block and Projection Lens. 4. Unscrew the 3 screws and remove the Lamp house. 5. Unscrew the 2 screws and remove the A-P.C.Board block (with WL-P.C.Board).
14
|
|
|
> |
|
