Connections/Initial Setup (Ready to Play)
Please make all cable or antenna connections before power on.
Connecting
For ANT./Cable Connect the cable from Antenna/Cable to the VHF/UHF terminal on the unit.
UNIT (rear view)
VHF/UHF
VHF/UHF
IN from ANT./CABLE
For DSS/Cable Box Connect the OUT jack on your cable box to the VHF/UHF terminal on the unit with a RF cable.
VHF/UHF UNIT (rear view) Cable TV Converter Box
VHF/UHF
WARNING:
Overtightening �Nut type� RF coaxial cables may damage jacks. Finger tighten only.
VHF/UHF
IN from ANT./CABLE
VHF/UHF
Initial Setup (Ready to Play)
Press COMBO on the remote for Combo mode.
1 2
Plug the unit power cord into AC wall outlet. Press POWER on the remote or unit. The unit comes on and auto channel and clock set starts.
If AUTO CLOCK SET IS INCOMPLETE screen appears, set the clock using MANUAL CLOCK SET procedure on next page.
� If you use a cable box, turn it on and set it to the Public Broadcasting Service (PBS) channel in your time zone. If you use a DSS receiver, it must be turned off.
AUTO CLOCK SET IS INCOMPLETE
CH AUTO SET PROCEEDING
PLEASE SET CLOCK BY PRESSING ACTION KEY
AUTO CLOCK SET PROCEEDING CANCEL : STOP
Notes
� Function buttons are inoperative during Initial Setup. � To remove a cassette during Auto Set, press EJECT twice on the remote ormust betwice on the unit. In this case, settings STOP made manually. (See page 10.) � Depending on conditions, Auto Clock Set may take longer than 30 minutes. If so, press STOP to stop setup and perform settings manually. (See page 10.)
3
Settings are made automatically. When setup is done, this screen appears.
2 / 6 / 2003 THU 12 : 00PM
DST : ON SETT I NG : CH 1 0 AUTO CLOCK SET COMPLETED
8
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to :
[email protected]
