|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It took about 24-hours after my payment before I was able to get to the download. Apparently, payment processing is not 100% automated. That is no big deal, just be aware of that going in.
After I got to it, it was in good shape, easy to read, etc. Not some cheap FAX copy looking thing.
Also, this site was the cheapest I found. Another Plus!
 ;
Good price, very legible manual, exactly what I needed -- but had to wait a day to actually get the download of the manual. Would have preferred to download it immediately after payment rather than waiting for someone to "process" my order. I was surprised that I had to wait that long.
 ;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
 ;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
PV-VM202 / PV-DAC12-A / VSK0611
3. Connect extention cable between the camera for PV-VM202 and the battery adaptor. 4. Turn power on the camera for PV-VM202 and set below function in the MENU. FLASH: ON (MENU => RECORDING SET UP => FLASH : ON) RED EYE REDUCTION : OFF (MENU => RECORDING SET UP => RED EYE REDUCTION : OFF) 5. Set 100cm between the grayed reflection sheet and camera. 6. Shoot it until full screen on the monitor LCD by zooming. 7. Press still button to take still picture. After flash, Picture must be stopped. 8. Connect AV cable to AV OUT/PHONES terminal and confirm the shot VIDEO level on the ocilloscope. 9. It should be �1.5 +- 0.1 V� as Fig. E2. 10. If not, adjust VR7001 and repeat procedure 7-9 again until 1.5 +- 0.1 V.
260
|
|
 |
> |
|