|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Before Using Setup on the Camcorder Using the Battery
Before use, fully charge the Battery. � We recommend using a Panasonic Battery. � We cannot guarantee the quality of this Camcorder when batteries from other companies are used.
Set [ REMOTE] on the [ SETUP] Sub-Menu to the desired Remote Control Mode. (pp. 22, 23)
Setup on the Remote Control
2 1
1 2
Attach the Battery to the AC Adaptor and charge it.
[VCR1]: Press the [Î�â�º] Button and [ â� ] Button simultaneously. 1 [VCR2]: Press the [â��Î�] Button and [ â� ] Button simultaneously. 2 â�¢ When the battery in the Remote Control is replaced, the mode is automatically reset to [VCR1] Mode.
Put the Battery on the Battery Mount by aligning the mark, and then securely plug it in.
Power Supply
Using the AC Adaptor
� Since the Battery will not be charged when the DC Cable is connected to the AC Adaptor, disconnect it from the AC Adaptor. � The [CHARGE] Lamp lights up, and charging starts. � When the [CHARGE] Lamp goes off, charging is completed. � When the battery is completely discharged, the [CHARGE] Lamp blinks at first, but the battery is charged normally. When the temperature of the battery is too high or low, the [CHARGE] Lamp blinks and the charging time becomes longer than usual.
3 1 2 3
Connect the DC Cable to the Camcorder. Connect the AC Cable to the AC Adaptor and the AC Jack.
Attach the charged Battery to the Camcorder.
Connect the DC Cable to the AC Adaptor.
� Before connecting or disconnecting the power supply, set the [OFF/ON] Switch 28 on the Camcorder to [OFF] and make sure that [POWER] Lamp 32 is not lit. (p. 18)
Set the [OFF/ON] Switch 28 to [OFF], and while sliding the [BATTERY RELEASE] Switch 39 , remove the Battery downward or DC Cable. � When attaching or removing Battery, set the [OFF/ON] Switch to [OFF] and make sure the [POWER] Lamp is not lit.
28
Disconnecting the Power Source
39
� Hold down the battery with your hand so it does not fall. � For other notes concerning this item, see page 59.
15
|
|
|
> |
|
