|
Who's Online
There currently are 5980 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I am proud of you. In the future, I benefited from your services.
;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
PV-GS19P / PV-GS31P / PV-GS32P / PV-GS35P / PV-GS19PC / PV-GS31PC / PV-GS34PC / PV-GS35PC
13. Installation of LCD Panel, Reflect Sheet, Lead Light Panel, Diffusion Sheet, BEF Sheet, BEF Sheet A, Panel Holder Unit a. When replacing the LCD Panel, the Diffusion Sheet, the BEF Sheet and the BEF Sheet A, make sure to remove the Protection Sheets. To distinguish Sheets from attached Protection Sheet: - A blue Protection Sheet is affixed to both faces of the Diffusion Sheet. - A yellow Protection Sheet is affixed to both faces of the BEF Sheet. - A transparent Protection Sheet is affixed to both faces of the BEF Sheet A.
Protection Sheet (blue) Diffusion Sheet
Reflect Sheet Lead Light Panel
adhesive tape
Diffusion Sheet (white)
Protection Sheet (yellow)
BEF Sheet
BEF Sheet (stripe) BEF Sheet A
Protection Sheet (green)
BEF Sheet A
(gray) slot slot hole adhesive tape hole cross mark LCD Panel cross mark
(L-5) Panel Holder Unit b. Use extreme care when handling the LCD Panel, the Reflect Sheet, the Lead Light Panel, the Diffusion Sheet, the BEF Sheet and the BEF Sheet A to avoid damage, dust, and spots (especially fingerprints, etc.) Install in order shown below. 1) Install in order the BEF Sheet A, BEF Sheet and Diffusion Sheet while inserting the corners of each sheets into the slots of the Panel Holder Unit. 2) Install the Lead Light Panel while inserting the corners into the slots of the Panel Holder Unit. 3) Align the Reflect Sheet with the edge of the Panel Holder Unit, and install it using adhesive tape on the Reflect Sheet. View A
adhesive tape
cross mark cross mark
Reflect Sheet adhesive tape
hole of Panel Holder Unit
View A Fig. D13-2
hole of Panel Holder Unit
Panel Holder Unit
Do not touch the surface of Lead Light Panel.
Fig. D13-1 4) Install the LCD Panel with adhesive tape so that the cross marks are positioned in the center of the holes in the Panel Holder Unit.
41
|
|
|
> |
|