|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
;
Great deal, you are the only one on earth who could deliver this old manual. Thx so much and have nice chrismas
;
Everything is OK. Owner's Manual I downloaded ( I get link for it by email).
Before Using Setup on the Camcorder Using the Battery
Before use, fully charge the Battery. � We recommend using a Panasonic Battery. � We cannot guarantee the quality of this Camcorder when batteries from other companies are used.
Set [ REMOTE] on the [ SETUP] Sub-Menu to the desired Remote Control Mode. (pp. 22, 23)
Setup on the Remote Control
2 1
1 2
Attach the Battery to the AC Adaptor and charge it.
[VCR1]: Press the [Î�â�º] Button and [ â� ] Button simultaneously. 1 [VCR2]: Press the [â��Î�] Button and [ â� ] Button simultaneously. 2 â�¢ When the battery in the Remote Control is replaced, the mode is automatically reset to [VCR1] Mode.
Put the Battery on the Battery Mount by aligning the mark, and then securely plug it in.
Power Supply
Using the AC Adaptor
� Since the Battery will not be charged when the DC Cable is connected to the AC Adaptor, disconnect it from the AC Adaptor. � The [CHARGE] Lamp lights up, and charging starts. � When the [CHARGE] Lamp goes off, charging is completed. � When the battery is completely discharged, the [CHARGE] Lamp blinks at first, but the battery is charged normally. When the temperature of the battery is too high or low, the [CHARGE] Lamp blinks and the charging time becomes longer than usual.
3 1 2 3
Connect the DC Cable to the Camcorder. Connect the AC Cable to the AC Adaptor and the AC Jack.
Attach the charged Battery to the Camcorder.
Connect the DC Cable to the AC Adaptor.
� Before connecting or disconnecting the power supply, set the [OFF/ON] Switch 28 on the Camcorder to [OFF] and make sure that [POWER] Lamp 32 is not lit. (p. 18)
Set the [OFF/ON] Switch 28 to [OFF], and while sliding the [BATTERY RELEASE] Switch 39 , remove the Battery downward or DC Cable. � When attaching or removing Battery, set the [OFF/ON] Switch to [OFF] and make sure the [POWER] Lamp is not lit.
28
Disconnecting the Power Source
39
� Hold down the battery with your hand so it does not fall. � For other notes concerning this item, see page 59.
15
|
|
|
> |
|
