|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Delivery came quite promptly and in a very readable format. Thank you.
;
I found my Clarion VRX8370R in the Camper I bought and I wasn't able for month to understand it.
The Owner Manual was perfect and just what I was searching for.
Thank you.
Leonardo
;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced.
Thanks, I will use you again.
;
Zeer duidelijke afdrukken op A4-formaat , zeer uitgebreide handleiding . Pluspunt ,zeer snelle
respons van jullie , binnen de 24h . Top !!!
;
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
Before Using Setup on the Camcorder Using the Battery
Before use, fully charge the Battery. � We recommend using a Panasonic Battery. � We cannot guarantee the quality of this Camcorder when batteries from other companies are used.
Set [ REMOTE] on the [ SETUP] Sub-Menu to the desired Remote Control Mode. (pp. 22, 23)
Setup on the Remote Control
2 1
1 2
Attach the Battery to the AC Adaptor and charge it.
[VCR1]: Press the [Î�â�º] Button and [ â� ] Button simultaneously. 1 [VCR2]: Press the [â��Î�] Button and [ â� ] Button simultaneously. 2 â�¢ When the battery in the Remote Control is replaced, the mode is automatically reset to [VCR1] Mode.
Put the Battery on the Battery Mount by aligning the mark, and then securely plug it in.
Power Supply
Using the AC Adaptor
� Since the Battery will not be charged when the DC Cable is connected to the AC Adaptor, disconnect it from the AC Adaptor. � The [CHARGE] Lamp lights up, and charging starts. � When the [CHARGE] Lamp goes off, charging is completed. � When the battery is completely discharged, the [CHARGE] Lamp blinks at first, but the battery is charged normally. When the temperature of the battery is too high or low, the [CHARGE] Lamp blinks and the charging time becomes longer than usual.
3 1 2 3
Connect the DC Cable to the Camcorder. Connect the AC Cable to the AC Adaptor and the AC Jack.
Attach the charged Battery to the Camcorder.
Connect the DC Cable to the AC Adaptor.
� Before connecting or disconnecting the power supply, set the [OFF/ON] Switch 28 on the Camcorder to [OFF] and make sure that [POWER] Lamp 32 is not lit. (p. 18)
Set the [OFF/ON] Switch 28 to [OFF], and while sliding the [BATTERY RELEASE] Switch 39 , remove the Battery downward or DC Cable. � When attaching or removing Battery, set the [OFF/ON] Switch to [OFF] and make sure the [POWER] Lamp is not lit.
28
Disconnecting the Power Source
39
� Hold down the battery with your hand so it does not fall. � For other notes concerning this item, see page 59.
15
|
|
|
> |
|
