Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
9. Removal of Jack C.B.A. & Bottom Angle Ass'y 1) Open the L Cover. 2) Remove the Screw (450) and release the Tripod Portion from the hole. Installation of Jack C.B.A. & Bottom Angle Ass'y Insert both the Jack C.B.A. & Bottom Angle Ass'y into the 2 slots and secure the Tripod into the hole.
450
11. Removal of Side Case R Unit Open and rotate the LCD to access the 2 Screws (419, 457) as shown below, then remove it. Installation of Side Case R Unit When installing, note to the direction of the Shaft Case Unit. Be sure to install the LCD (Ass'y) into the Side Case R Unit with the LCD rotated as shown. Otherwise, the LCD open/close switch on the Side Case R Unit will be damaged.
Open L Cover
LCD open/close SW.
419
Side Case R Unit
slot
Rotate
slot
hole Jack C.B.A. & Bottom Angle Ass'y Tripod
457
LCD (Ass'y)
Rotate
Fig. D9 10. Installation of Front C.B.A. 1) Install the Four Eyes Lens (For model with Light) into the Front Case. Then, install the Front C.B.A. with 2 bosses of the Four Eyes Lens and 2 Screws (533). 2) Install the Light Shield Sheet with 2 Screws (533).
533
Shaft Case Unit
Light Shield Sheet boss (For model with Light) Front Case Four Eyes Lens (For model with Light)
533
