|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what was needed to assess the product - excellent value and great service
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
alcohol and confirm that there is no dust in the TP Clip. 3. To achieve the best adjustment results, warm up the camcorder for approx. 30 minutes before adjustment. 4. When removing the TP Clip from S301 on the camcorder, be sure to pinch the grips.
Fig. E1-1
6. Set up the camcorder for adjustment as follows:
Fig. E1-2
Note: (in Method 1)
1. Connect the 46 mm Ring to the Infinity Lens. Then, insert it into the Light Box. 2. Set the camcorder so that the Decoration Ring of the camcorder is firmly against the 46 mm Ring. When performing this operation, ensure that there is no gap between the Decoration Ring and the 46 mm Ring and that no external light can enter.
Fig. E1-3
71
|
|
|
> |
|
