|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Caution
Make sure the monitor power is switched off (with the standby/ receive lamp switched off or red) before you connect or disconnect the speaker cables.
Attach the speaker systems to the monitor.
1
Attach the speaker brackets to the speaker systems.
In the case of (R) Speaker holder screw X 2 (R) (L)
Attach the screws in a position that allows you to read the speaker holder orientation markers (R), (L).
Notice
Use of cushions
In some cases, there can be a gap between the main unit and the speaker. You can attach the cushions provided to the side of the speaker system, if desired, to eliminate the gap.
Cushion Attach the cushions to the sides of the speakers facing the main unit. Align the cushions to the front of the back case and affix them.
R L
screw X 2
Speaker holder
Back case
Cushion
2
Attach the speaker systems to the monitor.
Remove two screws on each side of the monitor as shown and keep them for re-install. Loosen two screws on each side of the monitor as shown so that the speaker holders can be slide on to them. Insert the loosened screws into the engaging holes of the speaker holders that are attached to the speaker system, and slide the screws downwards. Next, use the previouslyremoved screws to fasten the speaker holders into the mounting holes in the monitor. Tighten the four screws to secure.
Monitor rear side
Right side
Loosen screws
ã�¹ã��ã�¼ã�«ã�¼ç«¯å� (6â�¦12W)
Remove screws
Speaker holder shown the other side
SPEAKER TERMINAL (8�8W)
Remove screws
Hook this section on the loosened screw
3
Attach the connection cables to the speaker system.
4
Attach the speaker connection cables to the monitor.
Speaker terminals
Treating the wire ends
Pull off while twisting
Connect the copper-coloured wire to the + side Connect the silver-coloured wire to the - side
ã�¹ã��ã�¼ã�«ã�¼ç«¯å� (6â�¦12W)
- Black + Red
ã�¹ã��ã�¼ã�«ã�¼ç«¯å� (6â�¦12W)
ã�¹ã��ã�¼ã�«ã�¼ç«¯å� (6â�¦12W)
Please prepare the supplied speaker cables.
��� ��� � �
Insert the wire Remove your finger
Connect the silvercolour wire
Connect the coppercolour wire
How to connect the speaker cables (Speaker side)
Press down the lever with your finger
How to connect the speaker cables (Monitor side)
Press the lever down
Insert the wire
Raise the lever
Caution required
Be sure to insert the speaker cables securely. Lock the connection terminal level securely.
64
|
|
|
> |
|
