|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
Setting Up and Using the Q5
Setting up your Q5 Headphone Amplifier is a simple procedure which takes only a few minutes: 1. Remove all packing materials (save them in case of need for future service) and plug the provided AC16 power adapter into the rear panel AC input�but don�t plug the adapter into a wall outlet just yet. WARNING: Do not substitute any other kind of power adapter for the provided one. The provided adapter is an AC step-down transformer; it is not a DC converter. Use of any power adapter other than the provided one can result in severe damage to the unit and will void your warrantee!!
2. Connect the output from the device you want monitored to the Left/Right Amp input jacks on the Q5 rear panel (if you�re using the Q5 with an audio patchbay, see the �Using The Q5 With A Patchbay� section on page 7). The Q5 accepts both balanced and unbalanced signal; generally, balanced signal is preferable because it provides better signal-to-noise ratio and reduced extraneous noise. 3. Turn the master Input knob and all five headphone Channel Output knobs to their minimum (fully counterclockwise) setting and then plug one to five sets of headphones into the front-panel Channel Headphone jacks. 4. Plug the Q5 power adapter into a wall outlet and switch the unit on by turning the Input Level knob clockwise. You�ll hear a click when first turning the knob and the Power LED will light up. Start by setting the knob to about the 3 o�clock position. 5. Apply a signal from the device connected to the Q5�s rear-panel Left/Right Amp input jacks. Put on the first set of headphones and slowly turn that headphone channel�s Output knob clockwise until you hear the desired level. WARNING: Because the Q5 is capable of generating extremely high signal levels, always start with the Channel Output knob at minimum and then slowly turn it up.
7
|
|
|
> |
|
