|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
QT-CD180H/QT-CD180W
� Focus failure.
Does the optical pickup move up and down when the disc is removed ? Yes Check as stated in item "FOCUS SERVO SAWTOOTH WAVE FAILURE".
No
Is the following waveform output at the pin 62 (FEI) of IC802 when the disc is set ? Yes
pin 62 (FEI)
No
Check the periphery of IC801 and BI801/CNS801. Is it normal ? Yes
The optical pickup is faulty.
pin 86 (FOO) pin 63 (SBAD)
Is the waveform shown above input at the pin 63 (SBAD) of IC802 ? Yes
No
Check the pattern between pin 13 of IC801 and pin 63 of IC802. Check the periphery of IC801 and BI801/CNS801.
IC801 is faulty.
� Focus servo sawtooth wave failure.
Is sawtooh wave output to the pin 66 (FOO) of IC802 ? Yes IC802 is faulty.
No
1.5~2.5sec
Is +8.1V applied to the pins 21 and 22 (VCC) of IC803 ? No Yes
Check the PWB pattern of IC803.
Is sawtooth wave obtained between pins 17 and 18 of IC803 ? Yes
No
Check the PWB pattern of IC803.
1.5~2.5sec
Is sawtooth wave obtained between pins 3 and 4 of BI801/ CNS801 ? (as shown above) Yes
Check the PWB pattern between BI801/CNS801 and IC803. No
BI801/CNS801 connection failure or optical pickup failure.
� 22 �
|
|
|
> |
|
