|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
;
Great Manual! It contains all the wiring schematics and mechanical exploded views that are essential for service and repair. I was surprised I even found this for such an old machine. Only wish I knew of this site many years ago.
;
Great manual very clear copied. You are making an incredible job. I appreciate a lot the rapidity and your efficiency. Thanks a lot
;
Good pdf of the service manual for this unit. Includes disassembly instructions, full schematics, board layouts, parts lists and diagnostic information. Some information is in the pdf twice (single pages, and split pages), but that could be how it was originally generated by panasonic, or perhaps the idea is to make it eaiser to put onto 8.5 x 11" pages.
Information was exactly what I needed. Delivery was overnight (less than 12 hours) and I was happy with the process.
QT-CD210H/W
� Laser failure.
Is +5V applied to the emiter of Q204 ? No Yes Check the PWB pattern of Q204.
Is +5V applied to the collector of Q204 ? Yes
No
Check the peripheral parts of IC803 and Q204.
Is +5V applied to the pin 75 (VDD) of IC802 ? No Yes Is +5V applied to the pin 1 (VCC) of IC801 ? No Yes
Check the PWB pattern between collector of Q204 and pin 75 of IC802.
Check the PWB pattern between collector of Q204 and pin 1 of IC801.
Is +0V applied to the pin 74 (SEL) of IC802 ? Yes
No
Check the laser come on when pattern cut between pin 8 (SEL) of IC801 and pin 74 (SEL) of IC802.
Is approx. 1.8V applied to the collector of Q801. Yes Check BI801/CNS801. If it is normal, the optical pickup is faulty.
No
Check the peripheral parts of IC801 and Q801. If it is normal, the optical pickup is faulty.
� Focus failure.
Does the optical pickup move up and down when the disc is removed? Yes Is the following waveform ouput at the pin 62 (FEI) of IC802 when the disc is set? Yes
pin 62 (FEI)
No
Check as stated in item "FOCUS SERVO SAWTOOTH WAVE FAILURE".
Check the periphery of IC801 and BI801/CNS801. Is it normal? No Yes The optical pickup is faulty.
pin 86 (FOO)
pin 63 (SBAD)
Is the waveform shown above input at the pin 63 (SBAD) of IC802? Yes IC801 is faulty.
No
Check the pattern between pin 13 of IC801 and pin 63 of IC802. Check the periphery of IC801 and BI801/CNS801.
� 19 �
|
|
|
> |
|
