|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
5-3. HOW TO REMOVE HANDS
Please remove the hands according to the following procedure. 1) Prepare the following tool, Hand removing spacer.
Code No.
Parts Name
Specification
1901 9721 Hand removing spacer
WAT-JIG510
f For the price of the above tool, please refer fto P.P.L.-510.510 F th i f th b tll t PPL
2) Fix Hour, Minute and Second hands to the same direction. 3) Place Hand removing spacer on Dial with EL. Be sure the three hands are in the hole of the hand removing spacer. 4) Remove the hands with the hand remover. Place the hand remover on the hand removing spacer as shown below. 5) How to fix the hands are the same way as the other watches.
Hand remover
Hand removing spacer
Movement holder
5-4. HOW TO INSERT THE BATTERY
1) 2) 3) 4) Place the new battery on the P.C.B. ass'y supporter. Set the battery on 2 and 4 o'clock side of the hooks of the P.C.B. ass'y supporter. Push down the battery at 9 o'clock side of the hook. Then the battery will be inserted. Be sure not to break the gasket of the battery by 9 o'clock side hook on 3) procedure.
Short circuit of P.C.B ass'y supporter and Battery.
�5�
Touching of the hook to the gasket of Battery
|
|
|
> |
|
