SHARP R362M
Owner's Manual

BEFORE OPERATION
Plug in the oven. 1. The oven display will flash the message shown opposite. 2. Press the STOP/CLEAR key. 3. Set the clock, refer to the next section. Use the STOP/CLEAR key to: 1. Erase a mistake during programming. 2. Stop the oven temporarily during cooking. 3. Cancel a programme during cooking, press twice.

STOP/ CLEAR

STOP/CLEAR key

SETTING THE CLOCK
After plugging in the oven, if you haven�t pressed STOP/CLEAR, do so now to clear the display.
STOP/ CLEAR

x1 Your oven is fitted with a 12-hour clock. To set the time of day, follow the guidelines given in the example below: EXAMPLE: To set the time of day, 12:35. 1. Press the AUTO START/CLOCK 2. Enter the hours, by pressing 5. Press the AUTO START/ key once. the 10 MIN key once and CLOCK key again. the 1 MIN key twice.
AUTO START CLOCK

10min.
x1 x1

1min.
x2

AUTO START CLOCK

x1 Check the display.

6. Enter the minutes by pressing the 10 MIN key three times and the 1 MIN key five times.

7. Press the AUTO START/ CLOCK key again to set the clock.

10min.
x3

1min.
x5

AUTO START CLOCK

x1

NOTES: � Once the time of day is set, you need only reset when the clocks change, if there is a power cut or if you disconnect the oven from the power socket. � If the clock is set and cooking is complete, the display will return to show the correct time of day. If the clock has not been set, the display will show:

6