|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Adjusting the Dolby Pro Logic II Music parameters ENGLISH
� When selecting the Dolby Pro Logic II Music mode, you can adjust the various surround parameters for optimum surround effect. � You can also adjust the Dolby Pro Logic II Music parameters with using the buttons on the front panel. (For details, refer to �SETTING UP THE SYSTEM ON FRONT PANEL� on page 43.) Press the PL II MUSIC PARAMETER button to select the desired parameter.
1
PL II PARA.
� Each time this button is pressed, the parameter changes and is displayed for several seconds as follows; Panorama mode(�PANO�, default value: OFF) This mode extends the front stereo image to include the surround speakers for an exciting �wraparound� effect with side wall imaging. Select �OFF� or �ON�. Center width control(�C-WID�, default value: 0) This adjusts the center image so it may be heard only from the center speaker, only from the left/right speakers as a phantom image, or from all three front speakers to varying degrees. The control can be set in 8 steps from 0 to 7. Dimension control(�DIMEN�, default value: 0) This gradually adjusts the soundfield either towards the front or towards the rear. The control can be set in 7 steps from -4 to +2. While displaying the desired parameter, adjust it as desired. Repeat the above steps 1 and 2 to adjust other parameters.
2
3
ADJUST UP(>), DOWN(<)
� If the parameter display disappears, start from the step 1 again.
29
|
|
|
> |
|
