|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual, great price. I am very pleased with Owner-Manuals.com, quick service, fast communication. Will definitely use this site again.
 ;
Hello from Germany - thank you very much for the manual for my Sharp "Searcher" - the handling of your internet area is outstanding..Mike
 ;
I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
 ;
The purchased manual is an high-quality scan of the original JVC paper-based Owner´s Manual. I am very satisfied!
 ;
Very satisfied with received document, all is right, Thank You very much, it was a Pleasure to work with You.
Assembly & Installation
! WARNING
Read and understand these instructions, tool manual, and router table manual for use of these accessories.
The RA1165 Under-Table Router Base is designed only for use with Bosch 1617/18 Series router motors.
FIG. 1
10-24x3/4� Screw
Mounting Plate Hole for Hex Wrench
Quick-release clamp lever and depth adjustment controls should face the front of the router table
ATTACHING BASE TO MOUNTING PLATE Attach the RA1165 to the router table�s mounting plate using either or both sets of enclosed mounting screws. The base has two sets of threaded holes for mounting the base: � Three 10-24 holes in industry-standard 3-hole pattern. � Four M4 holes in Bosch 4-hole pattern. Included mounting screws for the RA1165: � Three 10-24 x 3/4" screws. � Four M4 x 20 mm screws. If your router table mounting plate does not have countersunk holes in either of those patterns, you will need to determine the hole
2
locations, drill and countersink them, also locate and drill a hole for the over-table adjustment wrench. Note: Because each of the holes in the Bosch 4-hole pattern goes all the way through the base, it is easier to use it as a template for marking the mounting plate for drilling, than is the 3-hole pattern (which has one hole that does not go all the way through the base). The RA1165 should be positioned so that its quick-release clamp lever and depth adjustment controls face the front of the router table. (Fig. 1) Once the mounting plate has suitable countersunk mounting holes, attach the RA1165 using one or both of the attachment screw sets with a no. 2 Philips screwdriver.
|
|
 |
> |
|