|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
 ;
muy buen manual por lo completo de este algunos esquemas estan muy divididos lo que hace algo dificil el seguimiento.
;
very good manual, with detail and clarity in esquematic diagrams and waveforms .
;
Very quality copy of original service manual, which contains the circuit diagrams, PCB and lists of components, well as recommendation for calibration procedures of device, also everything else, that need for repair, tuning and use this oscilloscope.
All presented copies have high-resolution, so you can view all in detail.
This manual will very useful for simple owners and for repairers.
I recommend these manual, because myself is owner of Philips PM3216 and I need sometimes servicing these oscilloscope (principally calibrating).
Also, these document is an example of excellent design of technical documentation.
! CAUTION
1. In quiet or stopping operation, slight flowing noise of refrigerant in the refrigerating cycle may be heard, this noise is normal for the operation. During Thunderstorms, it is recommended to stop the operation and to disconnect the power cord plug from the power outlet. The room air conditioner does not start automatically after recovery from power failure to prevent the fuse from blowing. Press the START/STOP button after 3 minutes after the unit has stopped. When the room air conditioner is stopped by the thermostat or after miss-operation, the cooling and heating operation may not start for 3 minutes. This is not abnormal and is the result of the operation of IC delay circuit. The IC delay circuit ensures that there is no danger of blowing fuse or damaging parts even if operation is restarted accidentally. This room air conditioner should not be used for cooling operation when the outside temperature is below 10°C (50°F). This room air conditioner (the reverse cycle) should not be used when the outside temperature is below �10°C (14°F). If the reverse cycle is used under this condition the outside heat exchanger may become frosted and efficiency will fall. When the outside heat exchanger is frosted, the frost is melted by operating the hot gas system. In this condition the fan will stop and the vapour may rise from the outside heat exchanger.
2.
3.
4.
5.
6.
7.
�4�
|
|
|
> |
|
