|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
 ;
Complete manual, the good quality of reproduction allows enlarged print-out of the schematic diagram in the size it probably had in the original print edition and which is necessary for practical use.
;
The service manual was complete and the components on the drawings very good visible.
;
downloaded next day , manual is very helpful , fast and easy
;
This Service Manual was exactly what I needed to repair my Philips TV. The purchase was convenient and I received the manual at the same day I paid for it.
! CAUTION
1. In quiet or stopping operation, slight flowing noise of refrigerant in the refrigerating cycle may be heard, this noise is normal for the operation. During Thunderstorms, it is recommended to stop the operation and to disconnect the power cord plug from the power outlet. The room air conditioner does not start automatically after recovery from power failure to prevent the fuse from blowing. Press the START/STOP button after 3 minutes after the unit has stopped. When the room air conditioner is stopped by the thermostat or after miss-operation, the cooling and heating operation may not start for 3 minutes. This is not abnormal and is the result of the operation of IC delay circuit. The IC delay circuit ensures that there is no danger of blowing fuse or damaging parts even if operation is restarted accidentally. This room air conditioner should not be used for cooling operation when the outside temperature is below 10°C (50°F). This room air conditioner (the reverse cycle) should not be used when the outside temperature is below �10°C (14°F). If the reverse cycle is used under this condition the outside heat exchanger may become frosted and efficiency will fall. When the outside heat exchanger is frosted, the frost is melted by operating the hot gas system. In this condition the fan will stop and the vapour may rise from the outside heat exchanger.
2.
3.
4.
5.
6.
7.
�4�
|
|
|
> |
|
