The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
Text excerpt from page 8 (click to view)
Adjusting
the Oven Temperature
Control
Does Your oven seem hotter or colder than Your old oven? The temperature of Your old oven may have shifted gradually without You noticing the change. Your new oven is properly adjusted to provide accurate temperatures. But when comparing to Your old oven, the new design may give You difficult results. If after using the oven for a period of time, You are not satisfied with the temperature settings, they can be adjusted by following these steps:
OFF
LOCKING
1.
Pull the Oven Temperature Knob straight off.
OFF
Control
2. Loosen the locking
screw Note
the position of the notches.
OFF
TOOTH 3. To lower the temperature,
move the tooth a notch closer to LO. Each notch equals about 1O�F (5°C).
4. To raise the temperature,
move the tooth a notch closer to HI. Each notch equals about 10°F (5°C).
Tighten the locking screw and replace the control knob.