|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what was needed to assess the product - excellent value and great service
;
A site where discontinualed schematic diagrams and back dated information can be found on discontinued radios tv's and any electronic equipment can be found. Newer manuals either Service and operating manuals. Radio amateurs should find this site a great source for ham radio equipment manuals. I will return to this site should I need information on any electrical equipment. priced easy to download in a PDF format and print pages need to undertake the repair.
;
Quality scan of the original. All the detail necessary to troubleshoot, repair and adjust the unit. I'm sure I will be downloading more manuals in the future as the need arises.
;
Exactly as described, a Service Manual complete with the schematics and PCB layout delivered in a timely manner. Many thanks for the great service.
 ;
some of the writing is a bit blur but the part in the schmatic was great and i have fixed the machine thanks
RCD-W100
4-5. CD-RW Recording Adjustment and Self Record/Playback Check 1) Select the menu as follows. Control � Macro, and select 05cdrw_S.ttl. Press �Open�. Place the test CD disc PATD-012 on the Deck A. Place the recording CD-RW disc (see Note: 4-5-1) on the tray (Deck B) as prompted by the display and press �OK�. (Fig. 4-43) (The tray closes.) Note : 4-5-1 The disc to be used in this step. * * Use the CD-RW disc CWM74 for audio, that is manufactured by Sony. The disc that is used by this step cannot be used for the general purposes and for the purpose of operation check of the RCD series equipment as it is. The disc that is used for the general purposes or for the purpose of operation check of the RCD series equipment, cannot be used in this step. When you want to use the CD-RW disc for other applications, erase the CD-RW disc. If the recording is interrupted by any reasons during the recording operation (i.e., the WRITE POWER ON LED of the jig is lighting), the disc cannot be used any more in the subsequent step. In such a case, erase the CD-RW disc and repeat this step from the very beginning again. When the disc that is used in step 2) is the disc that has been used in the electrical adjustment in the past. ....... Press �Yes�. When the disc that is used in step 2) is a completely blank disc. ......... Press �No�. (Fig. 4-44)
4 Fig. 4-44 4 Fig. 4-43
2)
*
3)
Note: The recording CD-RW disc can be used only for the electrical adjustment. The recording CD-RW disc must be controlled so that it must not be used for any other applications. 4) Press the H button of Deck A. After playback starts, press �OK�. (Fig. 4-45)
4 Fig. 4-45
5)
When the message as shown in Fig. 4-46 appears some seconds later, stop playback (1X) and select 4x of the test mode (refer to page 19, Play Speed Selection Mode (Deck A)) Playback Speed. Then press the H button of Deck A. After playback starts, press �OK�.
4 Fig. 4-46
45
|
|
|
> |
|
