|
|
|
Who's Online
There currently are 5870 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
RFS12MPS, RCS10MPS and RCS10MP Control Panel Features
TIME ENTRY
TIME ENTRY pad is used to enter cooking time for either manual entry or programming. Cooking time ranges from 1 second (00:01)
to a total of 60 minutes (60:00) over four stages. If more than 60 minutes of total microwave cooking time is required, open door and inspect food before beginning new cooking cycle.
M I R O D EFR C W ARM M ED H I PO W ER
88:88
8
COOK LE VE L
CLOCK HOLD TIMER READY
X2
X2(some models) pad increases the cooking time when more than one item is cooked.
1
HOLD 0%
Numbered pads begin cooking programs or enter times and power levels for �Manual Time Entry� cooking. This oven can store up to 10 or 100 (some models) cooking programs in memory.
HOLD 0% DEFROST 20% MEDIUM 50% MED-HI 70%
2 3 4 5 6 7 8 9 0
POWER LEVEL (some models)
DEFROST 20% MEDIUM 50% MED-HI 70%
pads are used to set microwave power level. When cooking, the power level can be decreased for foods that require slower more even cooking. If cooking time is set and START pad pressed, oven cooks at 100% power. START pad begins Manual Time Entry cooking or restarts an interrupted cooking
START
TIME ENTRY STOP RESET
cycle. When programming, use to save time and power level, and to save a user option setting.
STOP RESET
STOP/ RESET pad exits programming mode and stop cooking during cooking cycle.
START
88:88
MICRO DEFR WARM MEDHI POWER HOLD TIMER
COOK LEVEL
8
READY CLOCK
Display Some items in display can be seen but are not available.
X2
Stages (some models) This oven can be programmed to run 4 cooking sequences consecutively. Each sequence is called a stage. For example, the first cycle could be programmed to defrost at 20% power, the second to hold at 0% power, the third to heat at 50% power, and the fourth to heat at 100% power. Total time for all cooking stages counts down. User Options User Options allow the user to program the oven to perform in a way convenient to the user. The beeps, maximum cooking time, and number of pre-programmed cooking sequences can be changed.
RCS10MPS and RFS12MPS Only
10
|
|
|
> |
|
