|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
;
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
 ;
Clear and easy to read. All details as expected. Price acceptable , and quick delivery.
;
Quick response and exactly what I was looking for and at a great fair price!
;
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
4 Double Auto Feed System How the automatic line feed works (F) F
1. When initially switching on the trimmer, a small length of line is fed out. 2. A �clattering� noise will be heard when the two nylon lines hit the line cutter. DO NOT BE ALARMED this is quite normal. After approximately 5 seconds the line will be cut to the correct length and the noise will reduce as the motor reaches full speed. � Make sure the motor is up to full speed before trimming or edging. 3. If the noise of the nylon line being cut cannot be heard, more line will need to be fed out. 4. To feed more line, it is first necessary to to allow the motor to stop completely, then re-start, allowing the motor to reach full speed. 5. Repeat step 4. until you hear the lines hitting against the cutter. (Do not repeat this procedure more than 6 times) 6. If problems are experienced with the automatic line feed refer to Fault Finding Chart.
line cutter
How to trim and edge
� WARNING � The use of eye protection is recommended. Do not lean over the trimmer whilst trimming or edging, objects may be thrown by the cutting line. Do not allow cutting head to rest on the ground. Do not overload your trimmer. Overloading can be avoided by making sure the motor speed does not drop unduly. Disconnect from the mains electricity supply before attempting any maintenance or adjustment. � BEFORE USE Make sure that both lines are fed out. � Make sure motor is up to full speed before trimming or edging. How to trim � The switchbox is provided with a lock-off button (G1) to prevent accidental starting. 1. Hold as illustrated in Fig H. 2. To start, press the lock-off button down (G1), whilst pressing the lock-off button squeeze the switch lever (G2). 3. When the trimmer starts release the lock-off button (G1). 4. Cut with nylon line at an angle using the tip See Fig H. 5. Swing trimmer in and out of the cutting area taking small cuts. See Fig J. 6. Line is fed out automatically every time the trimmer head stops rotating and returns to operating speed. � Extra line can be fed out manually as described on page 6. 7. To stop your trimmer release the switch lever (G2) How to edge 1. Hold as illustrated in Fig L. 2. To start, press the lock-off button down (K1), whilst pressing the lock-off button squeeze the switch lever (K2) 3. When the trimmer starts release the lock-off button (K1). 4. Rest edger on roller for extra stability and line up with the edge of the lawn, see fig M. Edge in direction indicated in fig L so that debris is thrown away from you. 5. To stop your trimmer release the switch lever (K2). 6. To return to trimming mode, turn trimmer over. � Ensure the electric cable is not snagged or pulled around sharp objects.
G
1
H
2
J
K
1
2
L
M
|
|
|
> |
|
