|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
;
The owners manual is very good. all my how to questions were answered in detail.
Adjusting
the oven temperature
control
Although your new ovens are properly adjusted to provide accurate temperatures, they may cook faster or slower than your old oven. If, after using the ovens for a period of time, you are not satisfied with the baking/ roasting results, you can change the temperature calibration by following these steps: 1. Make sure the Oven Temperature Control Knob is turned to the off position. Pull knob straight off and flip it over.
2. Loosen the locking screws inside the control knob. Note the position of the notches on the knob in relation to the skirt pointer. 3. To lower the temperature, hold knob skirt firmly and rotate the knob and notches in the direction of the LO arrow at the top of the skirt. Each notch equals about 10°F (5°C). 4. To raise the temperature, hold knob skirt firmly and rotate the knob and notches in the direction of the HI arrow at the top of the skirt. Each notch equals about 10°F (5°C). 5. Tighten the locking screws and replace the control knob.
Skirt pointer
Notches
Knob skirt
To raise
V
Locking screws
To lower
14
|
|
|
> |
|
