|
|
|
Who's Online
There currently are 5979 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
DEFROSTING ManualDefrost Models Frost comes from moisture entering the freezerwhenthedoorisopened, orclinging to packages placed in it, so it cannot be eliminated in non-frostless models. When frost is too thick -over 1/4 inch- it acts as an insulation which impedes freczing and reduces the effmiency of the unit. Todefrostyourfreezer, tumthetemperature control dial to "OFF*'. Remove frozen foods and wrap well in blankets or newspaper to prevent thawing. Leave the door open while the freezer is defrosting. You may use an electric fan to circulate warm air through the compartment for faster defrosting. DO NOT USE SHARP OR POINTED ARTICLES TO REMOVE THEICE. THEY CAN PIERCE AND DAMAGE THE UNIT. Do not allow water to stand in the bottom of the cabinet. Lay one or more bath towels in the bottom of the freezer to soak up defrost water. When all frost has melted, remove the towels and the water. Wash interior surfaces and removable parts with warm water to which a little baking soda has been added. Rinse well and dry thoroughly,
During power failures of longer duration, take steps to protect your frozen food by placing blocks of dry ice on top of the packages. If dry ice is not available, see if you can temporarily use a freezer in your local locker plant. BEFORE CALLING A SERVICE-
CABINET VIBRATES � Cabinet not level � Weak floor CABINET LIGHT NOT WORKING � Bulb burned out � No power at outlet
MAN, CHECK THE FOLLOWING LISTFORPOSSIBLETROUBLES THAT YOU YOURSELF CAN REMEDY CULTY. WITHOUT DIFFI-
NOISY OPERATION � Cabinet not level . Weak floor FREEZER � � � � WON'T RUN
Temperature control turned to OFF Line cord not plugged in No power at electrical outlet House fuse blown RUNS TOO LONG
FREEZER
� Control setdoor cold Prolonged too openings � Condenser needs cleaning � Poor air circulation around condenser
FREEZER RUNS TOO FREQUENTLY � Frequent running provides more stable temperatures � Too many door openings � Prolonged door openings FROZEN FOODS DRY OUT � Packages not wrapped or sealed properly ODOR IN CABINET o Odor producing foods should be covered � Interior needs cleaning MOISTURE COLLECTS ON OUTSIDE SURFACE � Hot humid weather increases conden sation. As humidity decreases, moisture will disappear. HEAVY FROST IN FREEZER � Frequent door openings � Prolonged door openings � Hot, humid weather increases frost build-up FREEZER COMPARTMENT WARM � Freezer control set too warm � Prolonged door openings TOO
No Frost Models No-Frost means that you will never have to defrost your Freezer. Frost is removed by air moving and collecting any moisture and depositing it on the cooling coil. The cooling coil periodically warms up just enough to melt the frost and it then flows down to the drain pan (located behind the base grille) where it is evaporated. REPLACING LIGHTBULB
IT IS RECOMMENDED THAT YOU DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT BULB REPLACEMENT. Use a 15 watt, intermediate base, appliance type bulb when replacing the light Most power rauures are corrected in an hour or two and will not affect your freezer temperatures. However, you shouldminimiTethenumberofdooropenings while the power is off.
Printed in U.S.A.
|
|
|
> |
|
