Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 7 (click to view)
4.7
Connecting the Device to the Electricity Supply
� The device must be connected to a properly earthed socket in line with
the relevant valid country regulations.
� Check prior to initial operation that the voltage
noted on the model label corresponds to the mains voltage. If this is not the case, do not connect the device and contact your dealer!
If the connection cable is damaged it must be replaced by the Customer Service at Dometic, or by respectively qualified personnel, in order to prevent any hazards.
4.7.1
Attention: For GB Only !
Plug connection (for United Kingdom only)
If a 3-pin plug is used, it should be fitted with a 3 amp fuse, with other plug types, the circuit should contain a 5 amp fuse.
Warning - This appliance must be earthed. IMPORTANT
The wires in the mains lead of this appliance are coloured in accordance with the following code: GREEN and YELLOW : EARTH BLUE : NEUTRAL BROWN : LIVE As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. 1. Connect the GREEN and YELLOW coloured wire to the plug terminal marked letter E or earth symbol or coloured green or green and yellow. 2. Connect the BROWN coloured wire to the plug terminal marked letter L or coloured red. 3. Connect the BLUE coloured wire to the plug terminal marked letter N or coloured black.
Moulded-On Plug Version
The mains lead is fitted with a non-rewirable moulded-on plug containing a 3 amp fuse. If the fuse requires replacing at any time, the fuse cover/carrier should be removed using a small screwdriver to level out. The old fuse should be replaced by a 3 amp ASTA approved BS1362 fuse and the fuse cover/carrier must be refitted before the plug is used again. If the fuse cover-carrier is lost, a replaceement can be obtained from the Dometic service Shops. The fuse cover/carrier must be of the same colour as that of the coloured insert in the base of the plug. In no circumstances must the plug be used without a correct fuse cover/carrier fitted. ......
