|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Mounting the Wall Unit
Warning
x10
Plasma LCD Plasma LCD
â� The Wall Mounting Unit should be mounted to a wall that can adequately hold the total weight of the plasma/LCD display and the Wall Mounting Unit over a long period of time and which can adequately withstand earthquakes, conceivable vibrations, and other external forces. Improper installation may cause the Plasma/LCD display to fall down, resulting in physical injury. Mounting On Wooden Walls The weight of the unit should be borne by the wall posts or studs, and these should be reinforced if insufficiently strong. Do not install the Wall Mounting Unit on walls made of plasterboard or thin plywood. Use the commercially sold screws best suited for the wall structure and material. Mounting On Concrete Walls Use commercially sold wall anchors capable of supporting the weight of the plasma display.
ENGLISH
â� Do not install the Wall Mounting Unit in a location which is hot or humid or which may become wet, as the presence of excessive moisture may lead to fire or electric shock. â� Do not install the Wall Mounting Unit near the blower or air inlet of an air conditioner. â� Do not install the unit in a location with a large amount of dust, soot, or cigarette smoke, as this may lead to fire.
Minimum 15 cm
Minimum 20 cm
â� Do not block the ventilation holes, and be sure to leave sufficient space around the unit for ventilation. Inadequate ventilation may cause the unit interior to overheat, leading to fire.
â� Do not install the Wall Mounting Unit in a location subject to frequent vibration, impact or other external forces. The unit may fall down or be damaged, causing physical injury. â� Do not install the unit in a location where people may hang on it or lean against it. Doing so may cause the unit to fall down or be damaged, resulting in injury.
â� Do not install the Wall Mounting Unit on a nonvertical wall. The unit interior may overheat, resulting in fire, or the unit may fall down, causing physical injury.
â� Do not install the unit in a location exposed to direct sunlight or strong light, as viewing the plasma display in an overly bright environment can be tiring for the eyes.
3
|
|
|
> |
|
