My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
The owners manual is very good. all my how to questions were answered in detail.
Text excerpt from page 14 (click to view)
With screws (see Fig. 20 and Fig. 22) To mount the door panel, follow these steps: 1. 2. Open the door 90 degrees. On new refrigerators, the decoration strip is taped inside the door; if installed on the door, remove the door decoration strip (2) by removing its three screws (1). Remove the old panel. Insert the new panel by inserting the vertical edges into the grooves of the door frame (3). Then, push the panel downwards so that the lower horizontal edge of the panel (4) is �tted into the bottom grove (5). Put the decoration strip across the door so that the gap is covered. Secure the decoration strip with the three screws removed in step 2.
1
With screws
Snap in
1
1 2
1 2
3. 4.
1
1
1
2
5. RM 2455 RM 2555 RM 4605 6.
Snap in (see Fig. 21 and Fig. 22) To mount the door panel, follow these steps: 1. 2. Open the door 90 degrees. On new refrigerators, the decoration strip are taped inside the door; if installed on the door, remove the door decoration strip (2) by gently pushing the four tabs away with a �at blade screwdriver (1). Remove the old panel. Insert the new panel by inserting the vertical edges into the grooves of the door frame (3). Push the panel downward so that the lower horizontal edge of the panel (4) is �tted into the bottom grove (5). Snap in the decoration strip (2).
