Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Text excerpt from page 14 (click to view)
With screws (see Fig. 20 and Fig. 22) To mount the door panel, follow these steps: 1. 2. Open the door 90 degrees. On new refrigerators, the decoration strip is taped inside the door; if installed on the door, remove the door decoration strip (2) by removing its three screws (1). Remove the old panel. Insert the new panel by inserting the vertical edges into the grooves of the door frame (3). Then, push the panel downwards so that the lower horizontal edge of the panel (4) is �tted into the bottom grove (5). Put the decoration strip across the door so that the gap is covered. Secure the decoration strip with the three screws removed in step 2.
1
With screws
Snap in
1
1 2
1 2
3. 4.
1
1
1
2
5. RM 2455 RM 2555 RM 4605 6.
Snap in (see Fig. 21 and Fig. 22) To mount the door panel, follow these steps: 1. 2. Open the door 90 degrees. On new refrigerators, the decoration strip are taped inside the door; if installed on the door, remove the door decoration strip (2) by gently pushing the four tabs away with a �at blade screwdriver (1). Remove the old panel. Insert the new panel by inserting the vertical edges into the grooves of the door frame (3). Push the panel downward so that the lower horizontal edge of the panel (4) is �tted into the bottom grove (5). Snap in the decoration strip (2).