|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
 ;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
 ;
Super nice! Good to have a manual in digital format.
 ;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
 ;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
INSTALLATION AND ASSEMBLY
(5) Paste spacer A (BMR1073) to the top board of the multi-projection unit and spacers B (BMR1074) to the two sides at the position shown in the figure after peeling off the seal. (7) Attach the attachments R and L to the unit through the top board of the unit using the screws (M6 � 20) and then attach attachments R and L to the unit from the back using screws (M6 � 20). (2 screws � 2 locations).
(6) Insert the multi-projection unit from the rear of the unit in this state.
4321 4321 4321
* Paste after adjusting the center of the top board to that of spacer A.
* Paste without covering the fan. *Drop the screw-lock fluid to screws so as not to loosen. (4 points)
(8) Check the Focus and reajust if necessary.
(9) Attach the cover (BNE1012) to the top board of the unit using the four screws (M5 � 15).
Screw (M5 � 15)
Unit
51
|