|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
http://getMANUAL.com
Location and Function of Controls
78
The effective keys for each projector model are limited to the functions of the projector. 1 1(on)/ u(standby) keys 1: Press to turn on the projector when the projector is in the standby mode. The POWER indicator lights in green when the power is turned on. When the PC series signal interface switchers (not supplied) are connected, they are turned on simultaneously. u: Press to turn off the projector and the switcher. 2 MUTING PIC/AUDIO keys Cut off the picture and sound. PIC: Press to cut off the picture. Press again to restore the picture. AUDIO: Press to cut off the sound. Press again to restore the sound. 3 LASER key Transmits laser beams from the laser transmitter of the Remote Commander. For safety purposes, this key is set to be relatively hard to press when it is used for the first time or after being unused for a while. Press it harder in such cases.
Front Left side
u
MUTING PIC
1
1
LIGHT
AUDIO
2 3
6
LASER
INPUT SELECT VIDEO SEL
4
C 3 6
A
B
SWITCHER
1 4 7
2 5 8
5
SW NO.
15
Location and Function of Controls
4 INPUT SELECT keys Select the input signal. VIDEO: Selects the signals of equipment connected to the projector VIDEO IN or the S VIDEO IN connector, and the AUDIO IN L/R connectors. SEL: Each time you press this key, the projector video input signal is switched between the composite video input and S video input. A: Selects the audio and video signals of equipment connected to the INPUT A connectors. B, C: Selects the signal of equipment connected to the Interface Board (not supplied). 5 SWITCHER keys Designate the input from the switcher when signal interface switchers (not supplied) are connected. To select an input, press the SW NO. key, and then press one of the numbered keys (1 to 8) to select the switcher by its number you have set. Then designate the input from the switcher by pressing a numbered key (1 to 8). Example: To switch to input 4 of the switcher 2, press the keys as follows: SW NO. n 2 n 4. If a numbered key is pressed without pressing the SW NO. key first, the input signal of the switcher 1 is selected.
Note
6 LIGHT switch Lights the back lighting for the Remote Commander. Press again to turn off the back lighting. If you do not press any key for more than 30 seconds, back lighting turns off automatically. 7 Infrared transmitter 8 Laser transmitter
Be sure to operate the keys within 2 seconds of each other. Key operation after 2 seconds is not effective. 16
RM-PJ3000S
1-3
|
|
|
> |
|
