|
There are currently no product reviews.
 ;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
INSTALLATION AND ASSEMBLY
(5) Paste spacer A (BMR1073) to the top board of the multi-projection unit and spacers B (BMR1074) to the two sides at the position shown in the figure after peeling off the seal. (7) Attach the attachments R and L to the unit through the top board of the unit using the screws (M6 � 20) and then attach attachments R and L to the unit from the back using screws (M6 � 20). (2 screws � 2 locations).
(6) Insert the multi-projection unit from the rear of the unit in this state.
4321 4321 4321
* Paste after adjusting the center of the top board to that of spacer A.
* Paste without covering the fan. *Drop the screw-lock fluid to screws so as not to loosen. (4 points)
(8) Check the Focus and reajust if necessary.
(9) Attach the cover (BNE1012) to the top board of the unit using the four screws (M5 � 15).
Screw (M5 � 15)
Unit
51
|
