|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
is part of the manual is very useful for repairing
Here are circuit diagrams
if there is damage, I recommend using this part of the
a complete list of circuit boards and components
 ;
Hello.
This paper enable me, to bring this lovley Scope into Function.
Without this Page, i have no cance to make this finish.
Hans M. Knoll Germany
;
I used for first time this the wheat and am very thanked
;
This manual was exactly what i needed and could not find elsewhere. Price is not too high. Great !
;
ecelent I was reciver the service manual soon I fell so happy very complete 100% positive all by this store tanks atte Luis salazar
SLV-E850B/E850UX/E880EG/F900B/F900NP/F900UX/F900VC/F990B/F990NP/F990UX/F990VC
RP-231 (REC/PB AMP) SCHEMATIC DIAGRAM � Ref. No.: RP-231 Board; 1,000 Series �
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this, the necessary note is printed in each block.)
� For printed wiring boards. � : Pattern from the side which enables seeing. � + : Through hole. Caution : Pattern face side: (Conductor Side)
Parts on the pattern face side seen from the pattern face are indicated. Pattern face side: parts on the parts face side seen (Component Side) from the parts face are indicated.
� For schematic diagrams. � Caution when replacing chip parts. New parts must be attached after removal of chip. Be careful not to heat the minus side of tantalum capacitor, because it is damaged by the heat. � All resistor are in ohms, 1/4W unless otherwise noted. Chip resistor are 1/10W unless otherwise noted. k�: 1000�, M�, : 1000k�. � All capacitors are in µF unless otherwise noted. pF : µ µF. 50V or less are not indicated except for electrolytics and tantalums. � : panel designation. � : internal component. � : B+ Line. � : B� Line. � : IN/OUT direction of (+,�) B LINE. � Circled numbers refer to waveforms. � Readings are taken with a PAL color-bar signal input. � Voltage are dc between ground and measurement points. � Readings are taken with a digital multimeter (DC10M�). � Voltage variations may be noted due to normal production tolerances.
When indicating parts by reference number, please include the board name.
4-5
4-6
4-7
REC/PB AMP
RP-231
|
|
|
> |
|
