|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Maintenance
Disinfection
If the feed water has a high content of micro-organisms, the water might develop an odour if the water purifier is not used for an extended period of time (1 week). It is then necessary to disinfect it. After the disinfection the filter has to be changed. The disinfectant, sodium hypochlorite (concentration approx. 3.5%, odourless), can be purchased from supermarkets or chemists. The disinfectant must be kept out of reach of children! Wash your hands after using it. 1. 2. Check that the water purifier is in standby mode. Press the service button, using a pen, until the service light comes on. Release the button. The light on the faucet now flashes rapidly for 15 seconds. This prevents flushing from taking place during disinfection. Disconnect the filter container in accordance with «Replacing the filter», points 2 - 5. Remove the filter and discard it (should not be saved). Fill the container with 7 dl of lukewarm water and pour in 1/4 dl of disinfectant. See fig. C. Screw the filled container in place. Start the water purifier and produce pure water for 30 seconds. While production is in progress, pull out the plug as shown in fig. D. Allow the water purifier to stand for around 30 minutes. Disconnect the container and insert a new filter into it, in accordance with «Replacing the filter», points 7 - 8. Connect the plug.
C
D
3.
4. 5. 6. 7.
8.
9.
10. Close the front cover. 11. Flush the water purifier in accordance with «Flushing». Do not use the purified water until flushing is complete. The disinfection process is now finished. The water purifier is ready to be used.
- 10 -
|
|
|
> |
|
