|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
;
Great deal, you are the only one on earth who could deliver this old manual. Thx so much and have nice chrismas
 ;
Everything is OK. Owner's Manual I downloaded ( I get link for it by email).
;
The only reason I gave this less than 4 stars, is because it shouldn't take 24 hrs to have the download available. I was surprised to find that I had to wait until the next day to be able to download the manual that I paid for.
The manual itself is the correct manual.
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM stations. Note: Preset numbers may have been set to factory test frequencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below:
Manual Presetting
1. Select a band (either AM or FM/FM-MONO) by pressing the TUNER BAND button.
TUNER
BAND FM MODE
2. Press the 4 or ¢ button to tune in a station.
REW MULTI CONTROL FF
3. Press the number key for more than 3 seconds to store in memory for the desired preset number. The preset number blinks for four seconds and then the preset station for the preset number appears. Example: To preset the tuned station to the preset number 15, press +10 then 5 for more than 3 seconds. The display changes as follows.
(Tuned station) (For 3 seconds)
4. Repeat above steps 1 to 3 for each station you want to store in memory with a preset number. To change the preset stations, repeat the same steps as above to overwrite a new station.
Auto Presetting ���������
In each band, you can automatically preset FM-30, AM-15 stations. Preset numbers will be allocated as stations are found, starting from the lowest station and moving up the frequency. 1. Select a band (either AM or FM/FM-MONO) by pressing the TUNER BAND button.
TUNER
BAND FM MODE
2. Press the AUTO PRESET button on the Remote Control for more than 2 seconds.
AUTO PRESET
(For 2 seconds)
3. Repeat steps 1 and 2 for the other band.
I If you want to change the preset stations, carry out the Manual
Presetting for the desired preset numbers. CAUTION: If no battery is loaded in the unit and it left with the AC adaptor unplugged (or when there is a power failure) for more than 24 hours, preset stations will be eliminated. Store all stations again after connecting the AC adaptor cord (or after electric power failure restores).
10
|
|
|
> |
|
