|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
 ;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM stations. Note: Preset numbers may have been set to factory test frequencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below:
Manual Presetting
1. Select a band (either AM or FM/FM-MONO) by pressing the TUNER BAND button.
TUNER
BAND FM MODE
2. Press the 4 or ¢ button to tune in a station.
REW MULTI CONTROL FF
3. Press the number key for more than 3 seconds to store in memory for the desired preset number. The preset number blinks for four seconds and then the preset station for the preset number appears. Example: To preset the tuned station to the preset number 15, press +10 then 5 for more than 3 seconds. The display changes as follows.
(Tuned station) (For 3 seconds)
4. Repeat above steps 1 to 3 for each station you want to store in memory with a preset number. To change the preset stations, repeat the same steps as above to overwrite a new station.
Auto Presetting ���������
In each band, you can automatically preset FM-30, AM-15 stations. Preset numbers will be allocated as stations are found, starting from the lowest station and moving up the frequency. 1. Select a band (either AM or FM/FM-MONO) by pressing the TUNER BAND button.
TUNER
BAND FM MODE
2. Press the AUTO PRESET button on the Remote Control for more than 2 seconds.
AUTO PRESET
(For 2 seconds)
3. Repeat steps 1 and 2 for the other band.
I If you want to change the preset stations, carry out the Manual
Presetting for the desired preset numbers. CAUTION: If no battery is loaded in the unit and it left with the AC adaptor unplugged (or when there is a power failure) for more than 24 hours, preset stations will be eliminated. Store all stations again after connecting the AC adaptor cord (or after electric power failure restores).
10
|
|
|
> |
|
