|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
Removing
To remove
the crispers
and crisper
cover
Pull out to the stop, lift the front and pull again.
the crispers:
1. Slide crisper straight out to the stop.
2. Lift the front. 3. Slide out the rest of the way. 4. Replace in reverse order.
To remove the cover: 1. Push up the cover insert from the bottom,
then slide out with both hands. 2. Lift front of cover frame. 3. Lift cover frame up and out.
To replace the cover: 1. Fit back of cover frame into notch supRemove the cover insert. Lift the cover front, then the back. NOTE: Handle glass insert with care. It could be heavy.
ports lower 2. Slide lower
on back wall of refrigerator, then the front into place. back of cover insert into place, then the front.
Y
Adjusting
(on some
the crisper
cover
track
models)
For your convenience, one crisper may be larger than the other, and your crisper cover may have an adjustable center track so you can switch positions of the crispers. This allows you to store celery and other longer items in a crisper. You can adjust the cover center track with the cover in the refrigerator by removing the crispers and the cover insert.
To remove the center track: Step 1 1. Push up the cover insert from the bottom,
then slide out with both hands. 2. Gently pull up on front end of track. 3. Pull rear end of track out of opening in cover.
To replace the center track: 1. Insert rear end of track (with hole) into
opening in cover. 2. Lower front end of track into slot. 3. Make sure rear end of track has snapped into place on underside of cover. 14
|
|
|
> |
|
