|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Adjusting the speaker settings
Adjusting the settings of front, center ,rear speakers, and subwoofer connected. If the speaker setting is adjusted to �S�, the low range bass sound of the channel(s) is redirected to the subwoofer or the front channels and if the speaker setting is adjusted to �N�, the sound of the channel(s) is redirected to other channels.
Select the desired speaker setting.
3
SPEAKER MODE
Each time this button is pressed, one of 11 different speaker settings are selected and displayed for 8 seconds as follows; FL CS RS, FL CL RS, FL CL RL, FL CL RN, FL CS RL, FL CN RL, FL CS RN, FL CN RS, FS CS RS, FS CS RN and FS CN RS In the displays, F stands for Front, C for Center, R for Rear, L for Large, S for Small and N for None. When judging whether a speaker is Large or Small, please note that a standard large speaker has a cone size larger than 12 cm(5 inches). The following speaker settings cannot be selected. Front :Small, Center : Large and Rear : Large(FS-CL--RL) or Center : None and Rear : None(CN-RN) setting. Select the desired subwoofer setting.
2
Press the SPEAKER MODE button for more than 2 seconds to enter the frontcenter-rear speaker mode.
SPEAKER MODE
The front-center-rear speaker setting is displayed. When the 6 CH DIRECT is selected as input source or �ANALOG� is selected as signal input in the stereo mode, the speaker mode function is not available. Memorize the desired speaker setting while it is displayed.
MEMO/ENTER
4
5
SPEAKER MODE
Each time this button is pressed, the subwoofer setting changes and is displayed for 8 seconds as follows; The desired speaker setting is memorized and then it enters the subwoofer mode. If the speaker setting display disappears, start from step 2 above, again. SUB W(oofer) -- Y(es): When using a subwoofer. SUB W(oofer) -- N(o) : When not using a subwoofer. In case that the front speaker is set to �S�, the subwoofer is automatically set to �Y�. Memorize the subwoofer setting while it is displayed.
MEMO/ENTER
6
Checking the speaker setting
SPEAKER MODE
If the subwoofer setting display disappears, start from step 2 above, again.
Each time this button is pressed briefly, the frontcenter-rear speaker or subwoofer setting is displayed.
15
E N G L I S H
|
|
|
> |
|
