|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
OEM manual provided all schematics, board layouts and component specs necessary to facilitate unit maintenance. All pages were clear and readable.
;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
;
Very very good as usual very trustable site. Perfect!!!!!!
RX-5030VBK
2.9 Removing the heat sink (See Figs.10 and 11) � Prior to performing the following procedure, remove the top cover and main board. (1) Remove the ten screws L attaching the heat sink. (See Fig.10) (2) From the reverse side of the main board, remove the two screws M attaching the heat sink. (See Fig.11) 2.10Removing the center amp. board, front amp. boards (L/ R) and rear amp. boards (L/R) (See Figs.10 and 12) � Prior to performing the following procedure, remove the top cover and main board. (1) Remove the ten screws L attaching the heat sink. (See Fig.10) (2) Remove the four screws N attaching the heat sink. (See Fig.12) (3) Disconnect the center amp. board from the connector CN321 on the main board. (See Fig.12) (4) Disconnect the front amp. board (L) from CN311 on the main board. (See Fig.12) (5) Disconnect the front amp. board (R) from CN312 on the main board. (See Fig.12) (6) Disconnect the rear amp. board (L) from CN331 on the main board. (See Fig.12) (7) Disconnect the rear amp. board (R) from CN332 on the main board. (See Fig.12) the connector the connector the connector
Heat sink
L
Main board
L
Fig.10
Heat sink
M
the connector
M
Main board
Fig.11
Front amp. board (R) Rear amp. board (L) Front amp. board (L) Rear amp. board (R) Heat sink Center amp. board
N
CN332 CN331 CN312 CN311
Fig.12
N
CN321 Main board
(No.22037)1-7
|
|
|
> |
|
