|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very quick response. Very good and accurate print quality of the scanned document.
 ;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
;
Excellent manual. Helped me out with disassembling and troubleshooting my projector.
;
thanks you are the best.Very good detail, Quick service response. A useful service manual with all details.
;
Great service!!! Polecam gorąco wszystkim zainteresowanym
RX-6000VBK/RX-6008VBK/RX-6100VBK Removing each board in the front panel assembly (See Fig.17 to 20)
Prior to performing the following procedure, remove the top cover and the front panel. 1. Pull out the volume knob on the front side of the front panel and remove the nut attaching the volume board. 2. Remove the three screws N attaching the volume board on the back of the front panel and disconnect the harness from connector CN411 on the volume board. 3. Remove the ten screws O attaching the system control board and disconnect the harness from connector CN402 on the system control board. 4. Remove the six screws P attaching the operation switch board. Push each tab b of the four joints inward and detach the operation switch board to the front. 5. Remove the screw Q attaching the operation switch board.
Front panel assembly
Nut Volume knob
Fig.17
O
O
N
CN411
N
O
CN402
O
Fig.18
Volume board
System control board
P
Tab b
Tab b
P
Fig.19
P
Q
System control board
Fig.20
2-6
|
|
|
> |
|
