|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Speedy transaction with a quick download. Awesome hassle-free service.
;
very poolite and healpful secure transaction thanks allot
;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
RX-6000VBK/RX-6008VBK/RX-6100VBK
Removing the regulator board / the rear -Rch amplifier board (See Fig.10 and 11)
Prior to performing the following procedure, remove the top cover. 1. Disconnect the harness from connector CN831 on Volume control the main board. board
CN512 Main board CN511 Regulator board Tie band Tie band
Main board CN831
Tie band
2. Remove the two screws H attaching the regulator board to the heat sink. 3. Disconnect the harness from connector CN511 on the main board and CN512 on the volume control board. Cut off the three tie bands fixing the harnesses. 4. Remove the two screws I attaching the rear-Rch amplifier board to the heat sink.
Rear-Rch amplifier board
Fig.10
Regulator board Rear-Rch amplifier board
H
I
Removing the main board (See Fig.12 and 13)
Prior to performing the following procedure, remove the top cover, the rear panel, the relay board and the preamplifier board. 1. Disconnect the card wire from connector CN811 on the main board. 2. Unsolder each harness connecting the power transformer and the main board. 3. Unsolder the power cord on the main board. 4. Remove the eight screws J board to the heat sink. 5. Remove the eight screws K board. attaching the main
Heat sink
Fig.11
K
Main board CN811 Speaker switch board
K
Soldered part
FW902 Power transformer
K
Main board
K J
Soldered part
Fig.12
J
Heat sink
attaching the main
6. For the harness extending from the speaker switch board, unsolder FW902 on the main board.
Power transformer
Main board CN811
Fig.13
2-4
|
|
|
> |
|
