|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Well-scanned, complete manual. Contains the information needed for repair and maintenance.
;
It's great to be able to obtain a precious technical information for a real old equipment. The one I got helps me a lot in the area of wiring diagram to repair my antique. PDF gave me clear enough information to find out thr details. Thanks for giving me the oppotunity to be able to access to almost vanished informations.
;
Another excellent aquisition. Fine detailed manual. Thanks
 ;
Good quality for the scan, complete, but as usual for Tascam, not so comprehensive !
;
great manual readable & easy to downlaod to be recommanded
RX-7012VSL
Removing the power supply board (See Fig.15 and 16)
Prior to performing the following procedure, remove the top cover and the front panel. 1. Remove the one nut attaching the headphone jack of the power supply board on the front side of the body. 2. Disconnect the harness connected to connector CN201,CN203,CN241 on the power supply board (If necessary, cut off the band fixing the harness on the side of the base chassis). 3. Disconnect the relay board to connector CN291 on the power supply board. 4. Remove the three screws P attaching the power supply board and pull out the power supply board from the front bracket backward. 5. Unsolder the three harnesses connected to the power supply board.
Power supply board
Headphone jack Nut
Fig.15
CN201 Headphone jack
P P
CN241
CN203 CN291 Hook
Solder points
P
Tie band Solder points
Removing the system control board / power switch board (See Fig.17 to 19)
Prior to performing the following procedure, remove the top cover and the front panel assembly. 1. Pull out the volume knob on the front side of the front panel and remove the nut attaching the system control board. 2. Remove the two screws Q switch board. attaching the power Fig.16
Operation switch panel Nut
Front panel assembly
3. Disconnect the harness from connector CN714 on the power switch board. 4. Remove the six screws R attaching the system control board on the back of the front panel. 5. On the back of the front panel, release the eight joints by pushing the joint tabs inward. Remove the operation switch panel toward the front. 6. Release the two hook attaching the system control board.
System control board
MASTER VOLUME knob
Fig.17
R
Joint
Joint
R
Joint
Power switch board Joint
Q
Hook Hook Joint Joint Joint Joint CN714
Fig.19
Fig.18
1-7
|
|
|
> |
|
