|
Who's Online
There currently are 5743 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
5. Adjust the speaker output levels as follows: � To adjust the center speaker level, press CNTR +/�. � To adjust the left rear speaker level, press REAR�L +/�. � To adjust the right rear speaker level, press REAR�R +/�.
ENTER
CNTR
MENU
2
REAR L
3
REAR R
Notes:
� You can adjust the speaker output levels and center tone
5
6
8
9
6. Press TEST again to stop the test tone.
TEST
4
7. Press CNTR TONE to select the center tone level you want. The center tone adjustment affects the mid-frequency range, which the human voice is mostly made up of. Each time you press the button, the display changes to show the following: SOFT2 SOFT1 FLAT SHARP1
CNTR TONE
without outputting the test tone. � You cannot adjust the center speaker level when �CENTER SPK� is set to �NONE� (see page 20). � You cannot adjust the rear speaker levels when �REAR SPK� is set to �NONE� (see page 20).
Note:
The center tone cannot be adjusted when �CENTER SPK� is set to �NONE� (see page 20).
1
SHARP2
Adjusted level are also shown on the on the equalizer display.
This CNTR means this adjustment can be applied to the center speaker only. (Example: When �FLAT� is selected.)
SEA
CNTR
100
1k
10k
To make the dialogue clearer, select �SHARP1� (little) or �SHARP2� (much). To make the dialogue softer, select �SOFT1� (little) or �SOFT2� (much). When �FLAT� is selected, no adjustment is applied. 8. Press EFFECT to select the effect level. Each time you press the button, the effect level changes as follows: DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3
EFFECT
Note:
You cannot adjust the effect level when �REAR SPK� is set to �NONE� (see page 20).
7/P
DSP EFFECT 5
DSP EFFECT 4
As the number increases, the surround effect becomes stronger.
To cancel the Theater Surround mode Press SURROUND MODE repeatedly until �OFF� appears. The DSP and THEATER indicators goes off.
40
English
|
|
|
> |
|