|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
RXD-302/302E/352/352E/372S
ADJUSTMENT
CASSETTE DECK SECTION
NO. ITEM INPUT SETTINGS OUTPUT CASSETTE TAPE S E T T I N G S DECK SETTINGS ALIGNMENT POINT ALIGN FOR FIG.
Unless otherwise specified : each ; switch should be set as follows : BEAT SW : OFF I. Cassette mechanism section (REC/PB head adjustment)
0dBs = 0.775V
{
[1]
Demagnetization and cleaning
�
�
Power OFF, demagnetization, cleaning play
REC/PB head, erase head. capstan, pinch roller
Demagnetize the REC/PB head by head eraser. Clean the REC/PB head, erase head capstan and pinch roller with a cotton swab immersed in alcohol. In a setting wher the output is maximized, adjust the azimuth adjustment screw so that the Lissajous figure appearing on the oscilloscope screen comes near to a line slanted45° Note : The head should be installed in such a manner that it approaches the tape face.
[2]
REC/PB head azimuth
MTT-114, TCC-153 SCC-1727 10 kHz, -10dB
(A)
PLAY
Azimuth adjustment screw
II. PC board adjustment MTT-111 TCC-100 SCC-1727 3 kHz, -4 dB TCC-120 315 Hz 0dB Put standard test tape (TCC-120) into B deck. (A) Put standard blank tape into A deck. Adjust so that Frequency is 3 kHz at the center of the tape. Approx. -5dBm reference level
< 1 > Tape speed
(A)
PLAY
SFR201
< 2 > Playback level
(A)
PLAY
Recording level <3>
Dubbing and playback.
Approx. -5dBm reference level
INSTRUMENTS CONNECTION Oscilloscope AC voltmeter
Frequency counter
Lch: PIN13(LA08) Rch: PIN8(LA06) PIN13 �
(A)
PIN8
IC401
MAIN UNIT
9
|
|
|
> |
|
