|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
 ;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
 ;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
RXD-951/A700/A900/V616/V818/V919
DISASSEMBLY FOR REPAIR
1. How to remove the front panel.
(1) Turn the power ON and then push the open/close key to open the tray. (2) After removed the tray cover, push the open/close key to close the tray and then turn the power OFF. (3) Remove the push rivet (1) and 4 screws (2, 3). (4) The front panel can be separated by removing the 3 screws (4) located at the bottom plate of the front panel.
6 x2 6 7 6 3 3 3 2 1
2. How to remove the CD mechanism
(1) Remove 4 screws (5) on the left side/right side of chassis. (2) Remove 4 screws (6) and the cap (7) on the rear panel. (3) Disengage the CD mechanism as FIG.2. (4) Connect the GND plate of X32 PCB and the chassis with a alligator clip wire (8).
5 x4 4 x3
Fig.1
3. How to remove the mult control knob.
� Remove the knob by string (9).
4. How to open the tray if not comes out.
(1) From the rear side of the CD mechanism, use a screw driver or the like to turn the friction arm fully counterclockwise. (2) Pull out the tray front wards by hand when the tray comes just out. * As for details of items in the below, refer to RXD-F3 service manual (B51-5091-00). (1) How to detach the tray. (2) How to attach the tray. (3) Replacing the pickup.
8
REAR SIDE Friction Arm
9
Fig.2
4
|
|
 |
> |
|