|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Service Manual received was helpful. The electronic information is exactly what I needed.
I recomend all of my friends about this technical page.
 ;
High quality scan of service manual. I am satisfied!
;
Excellent copies.
I will use "Owner Manual" again a second time.
;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
RX-DV3RSL
Removing the DVD / CD unit (See Fig.14)
Prior to performing the following procedures, remove the top cover, rear cover and DSP board. 1. Pull up the two plastic rivet attaching the DVD / CD unit dust proof cover, then remove the DVD / CD unit dust proof cover. 2. Remove the DVD / CD unit dust proof cover attaching on the main board. 3. Remove the three screws marked J attaching the DVD / CD unit. 4. Remove the bracket marked a attaching on the DVD / CD unit. Disconnect the connectors CN512 and CN513 on Plastic rivet Fig.14
Main board
DVD / CD unit
J
Dust proof cover
J
Bracket a
CN512 CN513
Removing the fan bracket
(See Fig.15)
Harness bands
Prior to performing the following procedures, remove the top cover, rear cover, video board, DSP board, amplifier board and S-video board. 1. If necessary, cut off the tie band fixing the harness. 2. Remove the two screws marked K attaching the fan bracket on the body. 3. Remove the harness bands fixing the harness on the fan bracket. 4. Disconnect the connector CN122 on the main board.
Power supply board Fan bracket
CN115 CN121 CN111 CN122
K
Main board
Removing the power supply board (See Fig.16)
Prior to performing the following procedures, remove the top cover, rear cover, video board, DSP board, amplifier board, S-video board and fan bracket. 1. If necessary, cut off the tie band fixing the harness. 2. Disconnect the card wire from the connector CN115 on the power supply board. 3. Disconnect the harness connected to the connector CN111 on the power supply board. 4. Remove the four screws marked L attaching the power supply board on the body. 5. Unsolder the solder points at the three harnesses connected to the power supply board.
Tie band Power supply board Solder points
Fig.15
L
CN115 CN121 CN111 CN122
L
Fig.16
1-8
|
|
|
> |
|
