|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
AM (MW/LW) antenna connection
Connect the AM (MW/LW) loop antenna supplied to the AM LOOP terminals. Turn the loop until you have the best reception. � If the reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. Keep the AM (MW/LW) loop antenna connected.
Connecting the Speakers
After connecting the front, center and rear speakers, and/or a subwoofer, set the speaker setting information properly to obtain the best possible Surround effect. For details, see page 15. CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.
FM antenna connection
Connect the FM antenna supplied to the FM 75 � COAXIAL terminal as temporary measure. Extend the supplied FM antenna horizontally. � If the reception is poor, connect an outdoor FM antenna (not supplied). Before attaching a 75 � coaxial cable (with a standard type connector), disconnect the supplied FM antenna.
Connecting the front, center, and rear speakers
1
2
2 1
3
Notes: � If the AM (MW/LW) loop antenna wire is covered with vinyl, remove the vinyl while twisting it as shown on the right. � Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.
For each speaker, connect the (+) and (�) terminals on the rear panel to the (+) and (�) terminals marked on the speakers respectively.
1 Cut, twist and remove the insulation at the end of each speaker cord (not supplied). 2 Press and hold the clamp of the speaker terminal (1), then insert the speaker cord (2). 3 Release the finger from the clamp.
Connecting the subwoofer speaker
By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software.
RIGHT RIGHT
LEFT/MONO
Getting Started
INPUT (LOW-LEVEL)
Powered subwoofer (example)
SUBWOOFER OUT
Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied). � Refer also to the manual supplied with your subwoofer.
Note: You can place a subwoofer wherever you like since bass sound is non-directional. Normally place it in front of you.
5
|
|
|
> |
|
